A furnace that won't ignite, short-cycles, or keeps tripping its limit switch needs more than a reset in Portland winters. A CO check happens on every call, standard, not an upsell.
Furnace failures in Portland cluster around a handful of parts — ignitors, flame sensors, gas valves, heat exchangers. We test with real equipment, not parts-cannon guessing.
What doesn't change from visit to visit.
A combustion analyzer reading for dangerous CO levels is part of every visit, not optional.
We bump no-heat calls ahead of routine visits when it's cold.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Our techs are trained equally on gas furnaces and electric heat strips, no exceptions.
The most common furnace failure points.
Cracked ignitors and carbon-fouled sensors cause a large share of no-heat calls, usually a same-visit fix.
Gas valve testing confirms the fault before we recommend replacing it.
We inspect carefully with proper equipment rather than assuming based on age.
We test both before condemning the control board.
Older Portland furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Tell us what the furnace is doing and we'll get someone moving.
Truck arrives stocked with common ignitor, flame sensor, and control parts ready to diagnose and often repair same visit.
Safety and diagnostic checks come first, then a flat-rate quote.
We re-check CO before signing off, backed by warranty.
Feedback from completed furnace repairs.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
Common questions before a Furnace Repair visit.
Clicking without ignition often points to the ignitor, but we confirm with a resistance test before quoting.
Yes — it can let combustion gases into breathing air, we won't run a confirmed-cracked unit, taken seriously.
Yes, included at no extra charge, no upcharge.
Yes — thermocouple and draft-related repairs are covered.
No-heat calls get priority routing, usually same-day even during high demand.
Common parts are stocked, rare ones may need next-day ordering to finish the repair.
We dispatch heating techs throughout Portland — call to confirm.
Call +1-844-611-2875
